Terma meg 1.0 электрическая схема

terma meg 1.0 электрическая схема
The endstop pins are Signal — GND — VCC, instead of the VCC — Sig — GND like the rest of RepRaps boards. The current (as of 2014-01-22) Marlin firmware is compatible with Arduino version 1.0.5. Some other firmwares may require Arduino software version 0023, NOT the most recent version. Once you start putting electricity into your RepRap — even at just 12 volts — you have to take basic, common sense precautions to avoid fires. Therefore the TxD level has to be divided by resistor.


Windows 8 will give this error: «The third party INF does not contain digital signature». If so, save the zip for the latest version of Arduino on your PC, and repeat the steps above with the driver folder in there. It should contain the digital signature Windows needs. You can use the 1×8 and 1×6 pin headers to jig them straight. Find the area labelled «endstops» in the upper right corner of the board and for each of the X, Y, and Z pairs of pins (label should be below each set) do the following: Connect S (top row, labelled to the left) on RAMPS to NC on the switch.

Remember to apply a heat-sink to the largest chip on the back. С помощью этого устройства можно автоматизировать включение-выключение ночного освещения в прихожей многокомнатной квартиры, в подъезде жилого дома или уличного освещения на дачном участке. Mechanical is in the folder ending with ME, optical endstop firmware is in the folder ending in OE. Working preconfigured Marlin firmware can be downloaded at . is for mechanical endstops. You will want to make sure that D1 is not installed or cut out. Просверлите в крышке корпуса отверстия под ось переменного резистора R4 и светодиода VD3, а так же отверстия для входного, выходного и измерительного кабелей;- смонтируйте на печатной плате перемычки;- отформуйте выводы компонентов и установите их на печатной плате. The board has the foot print of the components printed on it.

Похожие записи: